Here is a photo of my ilean setup showing how i connect the axle to the crank
arm.
From: Vi Vuong <dmarc-noreply@xxxxxxxxxxxxx>
To: "python@xxxxxxxxxxxxx" <python@xxxxxxxxxxxxx>
Sent: Friday, April 10, 2015 11:13 AM
Subject: [python] Re: Ilean connecting cranks to rear wheels
Hi James S
I am interested to see your set up also. You can submit small photos 150kb or
less. On my kiddie-wheel set up the wheel bearing balls sit on the inner pedal
cone and does not fit too well. The wheel cone can be used without
modification but if the hole is big enough for the pedal axle...
Thanks,
Vi
On Apr 10, 2015, at 10:22 AM, James Sullivan (Redacted sender
"poitco@xxxxxxxxx" for DMARC) <dmarc-noreply@xxxxxxxxxxxxx> wrote:
James,All you need to use are 4 wheel bearing inner races, two on each side to
attach to the pedal hole. The tapered side on the race will self align in the
pedal hole, no extra parts/machining needed. Contact me for a photo. I have
this setup on an MBB bike and if you use it in the 90 degree you will get free
suspension.
From: James Wells <jim@xxxxxxxxxx>
To: python@xxxxxxxxxxxxx
Sent: Friday, April 10, 2015 9:32 AM
Subject: [python] Ilean connecting cranks to rear wheels
I am planning an Ilean rear end for my existing Python. My question is about
connecting the cranks to the wheels. Rather than weld, I would like to use a
Helicoil type of device to reduce the crank hole so that it fits the wheel
axle. Any suggestions would be appreciated. Thank you. Jim Wells
--
Cell: 321-474-6289Website: www.web-showcase.com
Attachment:
photo.jpg
Description: JPEG image
