[python] Re: Fw: new pictures from kick-stand and seat
- From: Jürgen Mages <jmages@xxxxxx>
- To: "Python Malinglist" <python@xxxxxxxxxxxxx>
- Date: Wed, 19 May 2004 20:33:11 +0200
Bjørn,
> In your material list for the seat you mention one straight steel MTB
> handlebar. I guess this is the one that is welded to the fork's upper
> part and which servs as a fastening point for the seatbelts.
Yes, correct.
> In your last picture it seems that the upper piece of plywood is hinged
> to this handlebar. Is that correct?
Yes, it is bound with a piece of rope to the handlebar.
> The seat itself, i.e. the piece of plywood seems to be bolted to a
structure
> underneath. On the picture I can see a transversal bar which is welded to
> the tube/upper crank arm. Is this transversal bar part of a frame that is
> not visible on the picture (I can see the rear bolt on the left side)?
Yes, a 20x10 tube is welded transversal onto the upper crank arm. Through
this, three M6 bolts hold the plywood in place. This tube also holds the
seatbelts.
> The brake grips and the mirror also look as though they are attached to
> a handlebar which is welded to the before mentioned transversal tube.
Right. The outer 15 cm of the handlebar are cut off and welded onto the
20x10 transversal tube.
It is good, when you ask these kind of questions, because it helps me
to understand the problems, people have with my explanations and it
will improve the construction manual in the end.
Regards from Jürgen.
============================================================
This is the Python Mailinglist at freelists.org
Listmaster: Juergen Mages jmages@xxxxxx
============================================================
Other related posts:
