Hi all, I have kind of been in lurker mode since last summer . I now just purchased a little Gas MIG so I am now in bike building mode :) I am hoping to make a smaller wheel Python , at least on the front wheel, to fit my towering size of 5'4" with an inseam of 28 inches(71mm) I was looking at the two pictures and was wondering if the fact that the PX.1 has the pivot point in more line with the two axles helps make it more ridable. Any thoughts on this? Anyone have a 26" or 700c rear wheel and a 20 inch front wheel? Cheers, Paul Bell Ottawa area, Canada http://www.geocities.com/krazeeclimber/ > > The new pictures are: > http://www.python.tieflieger.net/pics/Python%20PX.0.jpg > http://www.python.tieflieger.net/pics/Python%20PX.1.jpg > > Notice that I changed the names of the two prototypes: > > PX.1 will be PX.0 > PX.2 will be PX.1 > ============================================================ This is the Python Mailinglist at freelists.org Listmaster: Juergen Mages jmages@xxxxxx ============================================================