Hi
They were inline... everything was fine till I sit down on bicycle.
Maybe if they were ball bearings it would be fine, but those were
sliding ones. They are just fine if they are used with horizontaly
oriented holes- but that is not aplicable for bicycle steering :)
I tried more succesfull to use long male screw (about 20mm in diameter)
in two long female screws as bearings- I only tested that, on stand, not
on bicycle. I'm not sure I'm so desperate to use it instead of normal
ball bearing headset. If I would build trike in future, then I will
probably try it as test.
Peter
Dňa 5.4.2016 o 9:50 Jürgen Mages napísal(a):
Thanks Peter,
are you sure they were perfectly aligned?
The alignment seems to be a bit of a problem of rod-end bearings, as mentioned before.
Jürgen.
On 05.04.2016 09:01, Peter Švančárek wrote:
Hi
I don't recommend those end rod bearings for steering. I tried 14mm ones
and even if I didn't break them, it was next to impossible to turn after
I sat on bicycle. Maybe this is better:
http://maydayseals.co.uk/706-home_default/lhsa6r-h-right-hand-ball-joint-rod-end-bearingm6-x-1.jpg
because it is made for stress in axis needed on bicycle.
I didn't try it though.
Cheers Peter
Dňa 5.4.2016 o 7:55 Jürgen Mages napísal(a):
On 05.04.2016 07:44, Lutz Wittgenstein wrote:
The 10 mm rod end bearings broke from the shearforce on the threat.
Did they break close to the bearing or close to the fastening nut
(picture maybe)? Did both rod-end bearings break or only one of them?
Sorry for being so specific, but I intend to improve our
pivot-wikipage, thus requiring more info.
Thanks,
Jürgen.
============================================================
This is the Python Mailinglist
//www.freelists.org/list/python
Listmaster: Jurgen Mages jmages@xxxxxx
To unsubscribe send an empty mail to python-request@xxxxxxxxxxxxx
with 'unsubscribe' in the subject field.
============================================================
============================================================
This is the Python Mailinglist
//www.freelists.org/list/python
Listmaster: Jurgen Mages jmages@xxxxxx
To unsubscribe send an empty mail to
python-request@xxxxxxxxxxxxx
with 'unsubscribe' in the subject field.
============================================================
============================================================
This is the Python Mailinglist
//www.freelists.org/list/python
Listmaster: Jurgen Mages jmages@xxxxxx
To unsubscribe send an empty mail to python-request@xxxxxxxxxxxxx
with 'unsubscribe' in the subject field.
============================================================
