You call 3 kg heavy? Each half of my python's frame weighed more than that :-).
Your design looks very interesting. Strengthwise, I'd be concerned about two
areas: the pivot joint (obviously) and the not very triangulated chainstayless
front end. Pull of the chain equals push of your leg amplified by
crank-length-to-chainring-radius ratio, which may be quite a lot.
Also, I recently saw 3D printed parts splitting like wood when loaded in an
inconvenient direction. Choose layer directions carefully.
Good luck!
Mirek
______________________________________________________________
Od: "Matthias B. Schönborn" <mbs@xxxxxxxxxxx>============================================================
Komu: python@xxxxxxxxxxxxx
Datum: 16.01.2019 20:52
Předmět: [python] Re: 3D printing
Unfortunately the frame will be quite heavy, I estimated it to weigh at
least 3 kg - without any gluing of the joints calculated in the weight.
Yes, I guess eventually the joints should be glued into the pipes. For a
temporary assembly without gluing I will also add holes to fix the tube
with a screw.
On 16.01.19 18:59, Jürgen Mages wrote:
Matthias, do you already have a weight estimation for the frame? Are
the joints glued into the pipes?
Am 15.01.2019 um 20:27 schrieb Matthias B. Schönborn:
Hello everyone,============================================================
I hope by putting the right subject I can make this message append to
the right thread, since I've not been a member of the mailing list at
that time. I've decided to try to build a python bike using PVC tubing
and joints printed from PETG. I've just created a page in the wiki,
which I hope we can have the discussion at:
http://en.openbike.org/wiki/Printed_Plastic_Python
I'm very much looking forward to a fruitful discussion!
For reference, you can also download the hole OpenSCAD design from
Github: https://github.com/mattbenscho/PrintedPlasticPython
Best regards,
Matthias
============================================================
This is the Python Mailinglist
//www.freelists.org/list/python
Listmaster: Jurgen Mages jmages@xxxxxx
To unsubscribe send an empty mail to
python-request@xxxxxxxxxxxxx
with 'unsubscribe' in the subject field.
============================================================
This is the Python Mailinglist
//www.freelists.org/list/python
Listmaster: Jurgen Mages jmages@xxxxxx
To unsubscribe send an empty mail to python-request@xxxxxxxxxxxxx
with 'unsubscribe' in the subject field.
============================================================
============================================================
This is the Python Mailinglist
//www.freelists.org/list/python
Listmaster: Jurgen Mages jmages@xxxxxx
To unsubscribe send an empty mail to
python-request@xxxxxxxxxxxxx
with 'unsubscribe' in the subject field.
============================================================