[pure-silver] Re: print washer
- From: Tim Daneliuk <tundra@xxxxxxxxxxxxxx>
- To: pure-silver@xxxxxxxxxxxxx
- Date: Mon, 17 May 2010 14:17:48 -0500
On 5/17/2010 2:03 PM, Elias_Roustom wrote:
> My Kodak syphon seems not to be working right, the low spout is putting
> water our continuously - I think it's only supposed to flush when the
> tub fills up right?
Well .... sort of. The siphon will spill some water before the tub
is full IIRC, but in general, once the tub is full, it should constantly
spill water. I kind of doubt your siphon is broken unless its cracked
or something ... there are essentially no moving parts in the thing other
than the clip that holds it in place.
> It's not magic, the face of each print has to be exposed to moving
> water. I can't just put a pile of prints in the tub and let the syphon run?
>
> I have (what I think is) a good home-made system. I run the water into a
> tub with holes at the bottom of it, and then I bring the prints up from
> the bottom one at a time continuously for 10 minutes - use a fixer
> remover solution for three minutes per 2 print (constant agitation and
> occasional change of position) - then another 10-15 minutes of the
> cycling around in running water. It's tiring late an night. I'm
> wondering if I can do better than that in terms of water usage and time
> standing there and actively washing.
>
> Thanks,
>
> Elias
>
>
> On May 17, 2010, at 2:35 PM, Jim Brick wrote:
>
>> Or try this...
>>
>> http://tinyurl.com/35klsut
>>
>> Jim
>>
>>
>>
>>
>> On May 17, 2010, at 11:07 AM, Elias_Roustom wrote:
>>
>>> this:
>>> http://www.freestylephoto.biz/111411-Premier-Print-Washer-11x14
>>>
>>> or this:
>>> http://www.buy.com/prod/8x10-auto-print-washer-standard-accepts-12-8x10-or-24-5x7-prints/q/listingid/75614672/loc/111/203349532.html
>>>
>>> Suggestions?
>>>
>>> Thanks,
>>>
>>> Elias
>>> =============================================================================================================
>>> To unsubscribe from this list, go to www.freelists.org and logon to
>>> your account (the same e-mail address and password you set-up when
>>> you subscribed,) and unsubscribe from there.
>>
>
--
----------------------------------------------------------------------------
Tim Daneliuk tundra@xxxxxxxxxxxxxx
PGP Key: http://www.tundraware.com/PGP/
=============================================================================================================
To unsubscribe from this list, go to www.freelists.org and logon to your
account (the same e-mail address and password you set-up when you subscribed,)
and unsubscribe from there.
Other related posts:
