Rein, Installed and did some tests. It is looking really good. I like the rsid sequencing. It works well. The only thing I noticed is that it does not return the RXrsid ON after a disconnect. I just added one line in the scanner section, before the scan mode tests, to systematically re-set RX rsid on and that seems to do the trick. But I think we need a re-set of RxRSID after disconnect too in case someone does not use the scan option. Also did a lot of testing of Fldigi's RSID receiving and there is definitely an issue regarding the sensitivity BEFORE the data is sent. If I enable post-frame RSID transmission, I get a much higher rate of mode change than by using the pre-frame one only. Something to look into since it is not practical and effective to use the post-frame RSID transmission (the data is already gone and there is an extra 1.5 sec delay after the data is sent). I will have a look at the RSID code in Fldigi to see if there is a difference between the two and will refer to Dave about this for help. Going bush this weekend so should have a fair bit of testing done. 73s, John On Thu, Nov 12, 2009 at 3:09 AM, Rein Couperus <rein@xxxxxxxxxxxx> wrote: > A new server is available at: > http://hermes.esrac.ele.tue.nl/pskmail/alpha. > > Version 0.9.23 fixes the 'already connected to xxx' bug, and > also handles PSK500 + RSID + scanning correctly. > It should be used with fldigi-3.13AZ (also in the same directory). > > 73, > > Rein PA0R > > -- > http://pa0r.blogspirit.com > >