In message <014f4881-350a-5193-0f49-aa6bbbd615e6@xxxxxxxxxxxxx>
Philip <sa3196@xxxxxxxxxxxxx> wrote:
I have Photodesk 3.14-17 running on a Titanium system Riscos 5.24 and
I am trying to calibrate the printer to what is on the screen.
If I go to print calibration box and chose linear press the eye and all,
move the bottom point up to 3 the photo lightens.
But if I then print the photo it prints darker than on the screen. If I
then move bottom point across the screen to 3 the photo gets darker.
If I then print the photo is lighter than the screen. They are working
opposite making calibration a little bit hard. What am I doing wrong.
I had a Beagle Board before and printing was very slow. Thought I would
try it out as it is a lot faster. The printer is a Epson Photo R2880
witch gives very good results.
Philip may
---
To alter your preferences or leave the group,
visit //www.freelists.org/list/photodesk