DJ, which tester you have? So many out there. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~ SirTroth ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~ ICQ: 1717439 ~ YAHOO: SirTroth ~ SKYPE: SirTroth ~ XFIRE: SirTroth ~ AIM/AOL: SirTrothX ~ http://ut2004.sirtroth.com ~ MSN: SirTroth@xxxxxxxxxxx (For MSN Chat) ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ =A0 -----Original Message----- From: pctechtalk-bounce@xxxxxxxxxxxxx [mailto:pctechtalk-bounce@xxxxxxxxxxxxx] On Behalf Of Gman Sent: Wednesday, June 04, 2008 5:58 PM To: pctechtalk@xxxxxxxxxxxxx Subject: -=3DPCTechTalk=3D- Re: Start Problem? DJ, Are you trying to take my job? lol Actually, I lost sight of the fact that you own a tester (most = normal=20 folks don't). You are absolutely right and it's better to use the = tester=20 since you'll get real time readings as you move the cable around and try = the pressure test on the end connections. If all looks good throughout, = then=20 we're back to pointing the finger at the board. Peace, G "The only dumb questions are the ones that are never asked" ----- Original Message -----=20 From: "cajun12" <cajun12@xxxxxxx> To: <pctechtalk@xxxxxxxxxxxxx> Sent: Wednesday, June 04, 2008 5:09 PM Subject: -=3DPCTechTalk=3D- Start Problem? > G-Man, new question: > > If the +5 volt pin in the 24 pin psu plug were faulty, would I not get = =3D > some faulty readings on the psu tester by moving the cable around as = you =3D > describe? > > dj=20 --------------------------------------------------------------- Please remember to trim your replies (including this sentence and = everything below it) and adjust the subject line as necessary. To unsubscribe or change your email settings: //www.freelists.org/webpage/pctechtalk To access our Archives: http://groups.yahoo.com/group/PCTechTalk/messages/ //www.freelists.org/archives/pctechtalk/ To contact only the PCTT Mod Squad, write to: pctechtalk-moderators@xxxxxxxxxxxxx --------------------------------------------------------------- --------------------------------------------------------------- Please remember to trim your replies (including this sentence and everything below it) and adjust the subject line as necessary. To unsubscribe or change your email settings: //www.freelists.org/webpage/pctechtalk To access our Archives: http://groups.yahoo.com/group/PCTechTalk/messages/ //www.freelists.org/archives/pctechtalk/ To contact only the PCTT Mod Squad, write to: pctechtalk-moderators@xxxxxxxxxxxxx ---------------------------------------------------------------