Can you send the full set of steps, commands, show configuration and show
database verbose, for the broke configuration?
Sent from my iPad
On Oct 11, 2018, at 04:59, Howard Latham <howard.latham@xxxxxxxxx> wrote:
Oracle 188.8.131.52 redhat 5.
I just cant get it to work!
Everything in the DGB setup looked fine. Even got it checked by a third
But just as last time we tried we got a message from broker saying cannot
switchover and primary was still primary but when I looked
then we had two standbys. Nightmare!
My question is why did that happen?
The standby/primary pair operate fine manually but I really wanted to use
My method to recover from this was
1. Connect to standby which should be primary. Alter database activate
2. Rman into standby which should be standby – restore database;
3. Start recovery at end of restore.
Howard A. Latham