Folks 1) IBM is recommending SAME (Stripe across all the 46 LUNs) + 2 separate LUNs for online redo logfiles 2) IBM is recommending 32 MB Stripe Unit size across the 46 LUNs using Volume Manager. NOTE - Each underlying LUN has 8 Disks (Hardware Raid 1+0 with Stripe Unit Size 64 KB - This is NOT changeable) Qs. Any feedback on impact of 32 MB Stripe Unit Size(across LUNs) on Performance of OLTP / Batch Transactions? For now we are also considering doing a Comparative benchmark of Performance of 32 MB versus 64 KB Stripe Unit sizes across the 46 LUNs. NOTE - We may NOT be able to do an exhaustive comparison. Hence any similar experiences would help very much. NOTE - In a previous VERY Small benchmark on a few CPUs machine & a Very Small Storage Box having just a Few Disks with single Software Striping(NO Hardware Striping) , Performance of our Application's Batch Runs was VERY POOR for Stripe Unit Sizes of 512 KB, 1 MB, 2 MB. Performance was Good for Stripe unit Sizes of 64 KB & 128 KB. Layout:- DB Server connects to -> 16 FC Controllers -> SAN Switch -> 18 FC controllers -> DS8300 Storage Box Filesystem = JFS2 1 DB Server - P595 model - 64 CPUs 2 APP Server - P595 model - Each having 64 CPUs NOTE - At a time Only 1 of OLTP or bath runs will happen Thanks indeed ________________________________ From: oracle-l-bounce@xxxxxxxxxxxxx [mailto:oracle-l-bounce@xxxxxxxxxxxxx] On Behalf Of VIVEK_SHARMA Sent: Thursday, May 11, 2006 6:58 AM To: kevinc@xxxxxxxxxxxxx; Oracle-L Subject: RE: To use SAME or NOT for High End Storage Setup ? Kevin, Folks For a DS8300 High End Storage:- Which one of the following 2 is advisable:- Qs. 1 Should ALL of the 47 (Hardware RAID 1+0) LUNs be Added into a Single Volume using Volume Manager (RAID 1 - Striping) - SAME concept? Qs. 2 Optionally should some "Optimal Num / sets" of these (RAID 1+0) LUNs be added / assimilated into different (multiple) Volumes (of RAID 1 - Striping)? If so, What should be this Optimal Num of LUNs per Volume (4,6 or 8 LUNs) ? NOTE - Database will be Laid out across all the 47 underlying LUNs Qs. 3 Being an OLTP type Banking application 64 KB Stripe Unit Size is being considered for Both of the following 2:- i) The underlying Hardware RAID1+0 for LUN creation ii) Also for the Volume Creation using Volume Manager (RAID 1 - Striping) Would folks advise using different Stripe Unit Size for the above (i) & ii)? Thanks indeed **************** CAUTION - Disclaimer ***************** This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message. Further, you are not to copy, disclose, or distribute this e-mail or its contents to any other person and any such actions are unlawful. This e-mail may contain viruses. Infosys has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. Infosys reserves the right to monitor and review the content of all messages sent to or from this e-mail address. Messages sent to or from this e-mail address may be stored on the Infosys e-mail system. ***INFOSYS******** End of Disclaimer ********INFOSYS***