Hi, Providing that you use the Kit-Q -Cut in a rear tool post it is OK. If used on a Myford in the normal tool post it will still dig in. Regards Clif ----- Original Message ----- From: "Shep" <shep.28@xxxxxxxxxxxx> To: "Modeleng" <modeleng@xxxxxxxxxxxxx> Sent: Sunday, December 02, 2007 10:56 AM Subject: [modeleng] Parting is such sweet sorrow! > Over the years, parting in the lathe was NOT sweet sorrow - what with > dig-ins, breaking of tools, spoiling of work etc etc. > Until I bought a Kit-Q-Cut parting tool from Greenwood Tools. It does > exactly what it says on the box! Problem solved! I can now part at > speed to the full depth of the tool, without any problems. > It has a small tungsten carbide tool inserted into a vertical plate, > narrower than the tool. > > I hasten to add the usual comment that I have no connection with this > supplier, other than being a satisfied customer. > > So, if parting is sweet (or other) sorrow, here is you answer! > > Cheers! > > Hubert. > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email to, > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject > line. > > > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.5.503 / Virus Database: 269.16.13/1164 - Release Date: > 02/12/2007 11:30 > MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.