Ron, my collets use a hollow draw bar that has a capacity of up to 1/2" diameter. They are 3AT collets, though. Al Messer --- Ron Head <ron.head@xxxxxxxxxxxxx> wrote: > Hi again Tony > > The problem with the drawbar type is that they > prevent you feeding bar stock > through the collet - kinda defeats the object > really. > > Ron > > ----- Original Message ----- > From: "Tony Wells" <oaksfield@xxxxxxxxxxxxxxx> > To: <modeleng@xxxxxxxxxxxxx> > Sent: Friday, September 02, 2005 8:11 PM > Subject: [modeleng] Re: Identifying collet chucks > > > > Thanks for this Ron. The lathe is a Myford, and > probably so are the > > collets. > > I had not thought of them selling their own > though, I must admit. At these > > prices, however, I strongly suspect that I will be > buying the draw bar > > type > > instead! > > > > Tony. > > > > > > ----- Original Message ----- > > From: "Ron Head" <ron.head@xxxxxxxxxxxxx> > > To: <modeleng@xxxxxxxxxxxxx> > > Sent: Friday, September 02, 2005 7:06 PM > > Subject: [modeleng] Re: Identifying collet chucks > > > > > >> Hi Tony > >> > >> They sound like ordinary Myford collets to me. > For some reason they are > >> like gold dust, new ones are around 25 pounds > each and you won't pick up > >> secondhand ones for under 15 pounds unless you > are very lucky. Myford > >> never > >> seem to have any on their stand. A complete set > of Myford collets in the > >> original box, secondhand will set you back around > 300 pounds, if you can > >> find one - they sometimes come up on eBay. > >> > >> Regards > >> Ron > > > > > > MODEL ENGINEERING DISCUSSION LIST. > > > > To UNSUBSCRIBE from this list, send a blank email > to, > > modeleng-request@xxxxxxxxxxxxx with the word > "unsubscribe" in the subject > > line. > > > > > > -- > > No virus found in this incoming message. > > Checked by AVG Anti-Virus. > > Version: 7.0.344 / Virus Database: 267.10.18/88 - > Release Date: 01/09/2005 > > > > > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email > to, > modeleng-request@xxxxxxxxxxxxx with the word > "unsubscribe" in the subject line. > __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.