Peter, Our bureaucrats and their asinine rules are bad enough, but at least we don't have to worry about those idiots over on the continent telling us what to do YET! They would like to get the US to disallow ownership of firearms, but so far they have been unsuccessful. There are liberals over here who want us to allow the UN to tell us everything that is right and they will keep trying to get their people in office at every election. The Wicked Witch of the West will surely run for president next time and there are probably enough idiots to vote for her to get her and her liberal crowd in office. Immediately, she and her cohorts will begin to try to erode our freedom more than already has been done. Governments seem to think that if the people were dumb enough to vote them in office, then they are also too dumb to know what is good for themselves. For a while we had a woman as head of OSHA (Occupational Safety and Health Administration). Among the other idiotic rules she came up with was that all toilet seats had to be exactly 17 inches tall in any establishment covered by the bureaucracy. I think people like OSHA and the EU have to come up with new rules all the time to justify their existence as the despicable bottom feeding parasites that they are. OFF OF SOAPBOX NOW On a lighter note, my Filer and Stowell is back together with flues that do not leak. All I am doing now is a bit of cosmetic additions like bolt heads on wheel counterweights, a handrail across the pilot and a foot board at the same location. Wheel weights on these little locomotives seem to have been made of two pie slice shaped pieces clamped between the spokes by a single through bolt at each location. Maybe I will add running boards along the boiler so my fireman can fill the sand dome also, but that might require hand rails..Any photos of "Blanche"? > Jesse > > > Still, working in Boston Lodge was fun. I spent the last couple of days > helping to put Blanche, over 100 years old, back together again having had a > new boiler fitted. > > Peter MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.