Jerry, it is quite probable that 5 pin is shorting to the ground. Look very carefully. - f Sent from BlackBerry® on Airtel -----Original Message----- From: <jerry@xxxxxxxxxxxxxxxx> Sender: minima-bounce@xxxxxxxxxxxxx Date: Tue, 25 Feb 2014 23:17:50 To: <minima@xxxxxxxxxxxxx> Reply-To: minima@xxxxxxxxxxxxx Subject: [minima] Re: Stuck in Transmit Is there supposed to be 5v on pin 5 of the digital board? I have 5v on pin 2 but nothing on pin 5. I tried the pullup resistor, didn't work. I changed the 4k7 to 47k on Q23, didn't work, still stuck in transmit. Jerry K5LRU Harwood, Texas > -------- Original Message -------- > Subject: [minima] Re: Stuck in Transmit > From: Thomas Sarlandie <thomas@xxxxxxxxxxxxx> > Date: Mon, February 24, 2014 8:48 pm > To: "minima@xxxxxxxxxxxxx" <minima@xxxxxxxxxxxxx> > > > What happens if you remove the wire from the T/R pin? > > Are you sure the PTT button is not stuck pressed or something like that? > > There are two things that can switch the minima in transmit: the ptt button > being pulled to ground (pin 5 of the arduino) or the cw key being pressed > (pin 24 of the arduino). > In normal rx configuration, both should be at +5V thanks to the internal > pull-ups resistors. > > thomas > > > On Mon, Feb 24, 2014 at 5:52 PM, <jerry@xxxxxxxxxxxxxxxx> wrote: > > > I finished my MB and hooked it to the controller. I connected the tune > > control to the control board and wired 12v to controller and 12v to the > > MB. I wired a switch to the Fn control pins, I wired the BFO pin on the > > MB to the BFO pin on the control board. I wired the T/R pin on the > > control board to the R/T pin on the MB. I wired pin 11 on the control > > board to the LPF pin on the MB. I left all the other pins on the control > > board empty. My LCD on power up reads: A 14,200 2 > > USB TX 0 > > I have power to the TX side of the MB. But pressing the FN does > > nothing. I can tune up and down freq., it changes from USB to LSB at > > the right times. but won't come out of tramsmit. Any ideas. > > > > K5LRU > > Harwood, Texas > > > > > >