Thanks Thomas, Steve and Adrian. I have a 4.7 k resister in there I will add a pullup resister and see if that works. I had company come over tonight so I had to stop working on it for awhile. Jerry K5LRU Harwood, Texas > -------- Original Message -------- > Subject: [minima] Re: Stuck in Transmit > From: Adrian Preda <ady.preda@xxxxxxxxx> > Date: Mon, February 24, 2014 11:16 pm > To: "minima@xxxxxxxxxxxxx" <minima@xxxxxxxxxxxxx> > > > Hi Jerry, > > As discussed days-weeks ago here on the group, the 4k7 resistor between T/R > pin on the MB and the respective pin on the DG is missing on the PCBs. My > fault forgeting it when I designed the pcbs. > Is the resistsor on the base of Q23. > You may consider using other values till it goes to Rx. I remember Mark used > a 47k. > > Adrian > YO4HHP > > > ________________________________ > From: "jerry@xxxxxxxxxxxxxxxx" <jerry@xxxxxxxxxxxxxxxx> > To: minima@xxxxxxxxxxxxx > Sent: Tuesday, February 25, 2014 3:52 AM > Subject: [minima] Stuck in Transmit > > > I finished my MB and hooked it to the controller. I connected the tune > control to the control board and wired 12v to controller and 12v to the > MB. I wired a switch to the Fn control pins, I wired the BFO pin on the > MB to the BFO pin on the control board. I wired the T/R pin on the > control board to the R/T pin on the MB. I wired pin 11 on the control > board to the LPF pin on the MB. I left all the other pins on the control > board empty. My LCD on power up reads: A 14,200 2 > USB TX 0 > I have power to the TX side of the MB. But pressing the FN does > nothing. I can tune up and down freq., it changes from USB to LSB at > the right times. but won't come out of tramsmit. Any ideas. > > K5LRU > Harwood, Texas