jerry, have u connected the keyer resistor? the keyer might be detecting a keydown (without the resistor) and permanently putting the transciever in transmit mode. - f On Tue, Feb 25, 2014 at 7:22 AM, <jerry@xxxxxxxxxxxxxxxx> wrote: > I finished my MB and hooked it to the controller. I connected the tune > control to the control board and wired 12v to controller and 12v to the > MB. I wired a switch to the Fn control pins, I wired the BFO pin on the > MB to the BFO pin on the control board. I wired the T/R pin on the > control board to the R/T pin on the MB. I wired pin 11 on the control > board to the LPF pin on the MB. I left all the other pins on the control > board empty. My LCD on power up reads: A 14,200 2 > USB TX 0 > I have power to the TX side of the MB. But pressing the FN does > nothing. I can tune up and down freq., it changes from USB to LSB at > the right times. but won't come out of tramsmit. Any ideas. > > K5LRU > Harwood, Texas > > >