[minima] Re: Arduino Software, and which board to select?
- From: Wayne McFee <nb6m@xxxxxxx>
- To: "minima@xxxxxxxxxxxxx" <minima@xxxxxxxxxxxxx>
- Date: Thu, 20 Feb 2014 18:35:58 -0800
Thanks, Steve,
I don't know about the bootloader, I just ordered a chip from Digikey.
Will have to check on that.
73,
Wayne
> On Feb 20, 2014, at 4:14 PM, "Steve VK2SJA" <vk2sja@xxxxxxxxxxx> wrote:
>
> Hi Wayne,
>
>> It would seem that you would use the Arduino software to upload the sketch
>> into it,since the Minima controller is a basic Arduino board?
>
> Correct.
>
>> And if so, which board type do you select for the Minima controller?
>
> I'd try "Arduino Uno" as it uses the ATmega328.
>
> Does your ATmega328 chip already have the Arduino boot-loader firmware
> installed? Won't work without.
>
> 73, Steve
> VK2SJA
>
>
>
>
>
Other related posts:
