[Linuxtrent] raid ed analisi dmesg

  • From: "El Kondor" <condorlnx@xxxxxxxx>
  • To: linuxtrent@xxxxxxxxxxxxx
  • Date: Wed, 31 May 2006 16:42:40 +0200 (CEST)

dopo aver ricreato l'arrai ho dato un occhiata a dmesg
e ho notato:

... cut ....
 /dev/ide/host2/bus1/target0/lun0: p1
[   31.960262] md: md driver 0.90.1 MAX_MD_DEVS=256, MD_SB_DISKS=27 [  
31.963758] md: raid1 personality registered as nr 3
[   32.158609] devfs_mk_dev: could not append to parent for md/0
 (?????? che è sta roba?)
[   32.160481] md: md0 stopped.
[   32.161034] md: bind<sdb1>
[   32.161154] md: bind<sda1>
[   32.161207] raid1: raid set md0 active with 2 out of 2 mirrors
[   32.167905] devfs_mk_dev: could not append to parent for md/1
[   32.169783] md: md1 stopped.
[   32.170305] md: bind<sdb3>
[   32.170427] md: bind<sda3>
[   32.170479] raid1: raid set md1 active with 2 out of 2 mirrors
[   32.180333] Attempting manual resume
[   32.180454] swsusp: Suspend partition has wrong signature?
[   32.208112] kjournald starting.  Commit interval 5 seconds
[   32.208119] EXT3-fs: mounted filesystem with ordered data mode. [  
34.866739] Adding 4923912k swap on /dev/sda2.  Priority:-1 extents:1 [  
34.890092] Adding 4923912k swap on /dev/sdb2.  Priority:-2 extents:1 [  
34.996298] EXT3 FS on md0, internal journal
[   38.091499] parport: PnPBIOS parport detected.
[   38.091551] parport0: PC-style at 0x378, irq 7 [PCSPP,TRISTATE] [  
38.176059] lp0: using parport0 (interrupt-driven).
[   38.193608] mice: PS/2 mouse device common for all mice
[   38.245250] ieee1394: Initialized config rom entry `ip1394'
[   38.248842] sbp2: $Rev: 1219 $ Ben Collins <bcollins@xxxxxxxxxx> [  
38.418913] logips2pp: Detected unknown logitech mouse model 1
[   38.490746] input: PS/2 Logitech Mouse on isa0060/serio1
[   39.057110] ts: Compaq touchscreen protocol output
[   40.655814] kjournald starting.  Commit interval 5 seconds
[   40.656386] EXT3 FS on md1, internal journal
[   40.656391] EXT3-fs: mounted filesystem with ordered data mode. [  
40.664076] kjournald starting.  Commit interval 5 seconds
[   40.664233] EXT3 FS on hde1, internal journal
[   40.664236] EXT3-fs: mounted filesystem with ordered data mode. [  
40.671496] kjournald starting.  Commit interval 5 seconds
[   40.671655] EXT3 FS on hdg1, internal journal
[   40.671658] EXT3-fs: mounted filesystem with ordered data mode. [  
41.494014] Linux agpgart interface v0.101 (c) Dave Jones
[   41.499561] agpgart: Detected an Intel 945G Chipset.
[   41.528368] agpgart: AGP aperture is 256M @ 0x0
[   41.586036] pci_hotplug: PCI Hot Plug PCI Core version: 0.5
[   41.589298] shpchp: acpi_shpchprm:get_device PCI ROOT HID fail=0x1001 [
  41.721973] PCI: Setting latency timer of device 0000:00:1b.0 to 64 [  
41.970340] shpchp: acpi_shpchprm:get_device PCI ROOT HID fail=0x1001 [  
42.039752] shpchp: acpi_shpchprm:get_device PCI ROOT HID fail=0x1001 [  
42.289430] hw_random: RNG not detected
[   42.618402] ohci1394: $Rev: 1250 $ Ben Collins <bcollins@xxxxxxxxxx> [ 
 42.671794] ohci1394: fw-host0: OHCI-1394 1.1 (PCI): IRQ=[23]
MMIO=[e4008000-e40087ff]  Max Packet=[4096]
[   43.841065] Real Time Clock Driver v1.12
[   43.917404] input: PC Speaker
[   43.931574] ieee1394: Host added: ID:BUS[0-00:1023]
GUID[0014855600365e77]
[   44.160509] Floppy drive(s): fd0 is 1.44M
[   44.175400] FDC 0 is a post-1991 82077
[   44.643137] sr0: scsi3-mmc drive: 40x/40x writer cd/rw xa/form2 cdda tray
[   44.643142] Uniform CD-ROM driver Revision: 3.20
[   44.646035] Attached scsi CD-ROM sr0 at scsi1, channel 0, id 0, lun 0 [
  44.681674] Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0,
 type 0
[   44.687056] Attached scsi generic sg1 at scsi0, channel 0, id 1, lun 0,
 type 0
[   44.690869] Attached scsi generic sg2 at scsi1, channel 0, id 0, lun 0,
 type 5
[   47.375557] tg3: eth0: Link is up at 100 Mbps, full duplex.
[   47.375561] tg3: eth0: Flow control is on for TX and on for RX. [  
47.602578] NET: Registered protocol family 10
......cut .......

ma sarà grave? intanto tutto va.....
:)

-- 
Per iscriversi  (o disiscriversi), basta spedire un  messaggio con OGGETTO
"subscribe" (o "unsubscribe") a mailto:linuxtrent-request@xxxxxxxxxxxxx


Other related posts: