I have seen this problem in a couple of different scenarios... I
think we may need to issue a device reset if when we get a timeout
error. It would also be nice if we could figure out what is causing
it to become unresponsive.
Geoff On Feb 24, 2006, at 10:49 AM, numE wrote:
I just tried passive scanning again with my dwl-122. i had to restart sometimes in the past to get it running, but now i tried it several times and always had no luck.
console log:
2006-02-24 18:45:47.564 KisMAC[10150] USBIntersilJack is now ready to
start working.
2006-02-24 18:45:47.889 KisMAC[10150] USBIntersilJack: Detected a Prism2
card
2006-02-24 18:45:47.928 KisMAC[10150] USBIntersilJack: Firmware vendor
31, variant 1, version 1.7
2006-02-24 18:45:47.929 KisMAC[10150] USBIntersilJack: MAC 0x0 0x11 0x95
0x82 0xad 0x66
2006-02-24 18:45:48.037 KisMAC[10150] error from async interruptRecieved
(e00002e8)
2006-02-24 18:45:48.038 KisMAC[10150] unable to do async interrupt read
(e000404f). this means the card is stopped!
2006-02-24 18:45:53.001 KisMAC[10150] Timeout error.
2006-02-24 18:45:53.002 KisMAC[10150] Timeout error.
any hints?
greetings,
numE
