How long before they will support injection do you think? Also,
sorry that I can't help Lawrence, thats really too bad... Also
(macuser), are there usb ralink cards, because I'm on an iBook
(G4) without pcmcia slots...
On 4/17/07, themacuser <themacuser@xxxxxxxxx> wrote:
Prism2 cards are actually b only, and the network is only in g
traffic. Wait for ralink cards to support injection. Yes, this is
said
to be the univeral solution to everything. But thats why we are doing
it...
On 4/18/07, Lawrence Bean <lbean@xxxxxxxxxxxxx> wrote:
> kismac@xxxxxxxxxxxxx writes:
> >I'd go for the wusb11 if I were you. I've had the most luck
with it.
>
> Hey Jake.
>
> I picked up a Linksys WUSB11 v2.5 and have just started playing
with it
> and Kismac. I'm using a G3 iBook with 10.4.9, have downloaded/
compiled
> 0.21a from the USB branch, and have not installed any other
drivers. I
> have a WAP network (a linksys, average signal 36) within easy
reach of my
> condo and touched base with the owner about running a sample
hack ... to
> practice and to help them shore up their perimeter.
>
> I watched the video
> http://www.youtube.com/watch?v=G38PD5FyUxE
> and selected USB Device, passive mode as primary injection. I
homed in on
> the main channel and hub, and after collecting a couple hundred
data
> packets chose "Authentication Flood". When I do this, after
about a minute
> the signal goes to zero and no further packets are collected. If
I stop
> the flood, signal goes back to normal and packets are collected
again. If
> I choose "reinject packets", I get a box saying "waiting for
interesting
> packets" and packets continue to be collected, but after a while
I get
> "unable to start a reinjection attack because the network seems
not to be
> reacting".
>
> Do you have any hints for me, or can you describe a setup you know
> cracking WEP worked so I can verify my installation is correct?
>
>
>
>
