-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 >>> Any idea why channels 12 and 13 cannot be enabled on this card by the >>> way? > > Any means of overriding this, or flashing the firmware? Probably my > own fault, cause I bought the card 'cheap'... you will need to flash the primary firmware, i dont think this is possible with any free-available software. >> these channels are not allowed over there. i ll put out a new >> version of kismac tonight. it will fix some bugs, and the macjack >> driver should now tell the firmware revision upon startup (in >> system.log). but i'll announce it later. > > This is what came up (and has come up every 2 seconds in the last > 24h, totalling to over 4 MB of system.log file contents) when Kismac > runs. Then I quit Kismac, uninstalled, installed the new version, > started the new version, scanned all channels for a few seconds, > stopped scanning and quit kismac, see here: the latest release has debug info enabled. just ignore the waitfornotbusy errors. > Hope this helps; I guess my card version is 8.40 US. > > BTW, Mick, it is pretty confusing to have more than one version > called 0.04d; how about 0.04d1, 0.04d2 etc till 0.04e will be > released? ok. maybe not a bad idea mick -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.1 (Darwin) iD8DBQE+ti9e6ssxlS0dtH4RAqsJAKDCTrOb+Y+4aKh/v8N83mCSRMDC0wCfeJZb Ijo0xbkfBvNGrJ/MhOyJyvE= =2DMG -----END PGP SIGNATURE-----