Actually, that is not correct. DecTalk Access32 can be used perfectly with any version of JAWS under any Windows operating system. I have used DecTalk with every version of JAWS I obtained and it works perfectly. During the installation, you are warned that JAWS 3.2 was not detected on your system. This is an error that can be ignored, and you can still use the synthesizer with JAWS. -Grant Hardy Email/MSN: grant_hardy@xxxxxxxxx -----Original Message----- From: jfw-bounce@xxxxxxxxxxxxx [mailto:jfw-bounce@xxxxxxxxxxxxx]On Behalf Of Loreal Sent: Wednesday, March 31, 2004 9:11 PM To: jfw@xxxxxxxxxxxxx Subject: JFW4.51.119 and Decktalk Access32 Correct me if I am wrong, but it isn't possible to use decktalk access with JFW4.51.119 and XP, correct? I thought I had read somewhere that it's not doable but I could be wrong. If I am, could someone talk me through doing it? Thanks!!! in advance either way was just wondering... Loreal -- To post a message to the list, send it to jfw@xxxxxxxxxxxxx To unsubscribe from this mailing list, send a message to jfw-request@xxxxxxxxxxxxx with the word unsubscribe in the subject line. Archives located at: //www.freelists.org/archives/jfw If you have any concerns about the list, post received from the list, or the way the list is being run, do not post them to the list. Rather contact the list owner at jfw-admins@xxxxxxxxxxxxxx -- To post a message to the list, send it to jfw@xxxxxxxxxxxxx To unsubscribe from this mailing list, send a message to jfw-request@xxxxxxxxxxxxx with the word unsubscribe in the subject line. Archives located at: //www.freelists.org/archives/jfw If you have any concerns about the list, post received from the list, or the way the list is being run, do not post them to the list. Rather contact the list owner at jfw-admins@xxxxxxxxxxxxxx