Also, do the clients have ISA client installed and enabled? -----Original Message----- From: Brian leal [mailto:bleal@xxxxxxxxxxxxxxxxx] Sent: 21 May 2002 04:02 To: [ISAserver.org Discussion List] Subject: [isalist] Re: permitting special ports to listen http://www.ISAserver.org I created a protocol definition for each port (7100, etc) so that inbound connections can be made. I then created a protocole rule allowing internal clients inbound/outbound access using the newly defined protocol definitions. Still no luck. When I run "netstat" the ports are not listening. >>> swright@xxxxxxxx 05/21/02 12:48 PM >>> http://www.ISAserver.org Did you create an inbound protocol definition and then a protocol rule? ----- Original Message ----- From: <bleal@xxxxxxxxxxxxxxxxx> To: "[ISAserver.org Discussion List]" <isalist@xxxxxxxxxxxxx> Sent: Monday, May 20, 2002 9:01 PM Subject: [isalist] permitting special ports to listen http://www.ISAserver.org We have ISA installed (Proxy/firewall) with secureNAT clients. The clients use an application that requires three special ports to be open and listening on the firewall at all times. The ports are 7100,7150 and 7200. I've created a packet filter for these ports (Both directions) and still they are not listening. What else needs to be configured? Also, how can I map these ports so that they have a permanent connection to a server on the internet? Is there a "NATING" feature similar to RRAS within ISA? ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: swright@xxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub') ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: bleal@xxxxxxxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub') ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: richard@xxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub')