RE: cisco vpn dialer (IPSEC)
- From: "Jeffrey M. Butte" <jbutte@xxxxxx>
- To: "[ISAserver.org Discussion List]" <isalist@xxxxxxxxxxxxx>
- Date: Wed, 7 Nov 2001 00:01:52 -0600
I assume you are getting a connection to your client behind ISA but it
is stopping there.... Configuring your client depends on if and how it
was customized. The config may be different for everyone.
1.) Configure your client to use IPSEC through NAT Mode (general tab
under properties)
2.) Connect the client to the Altiga box.
3.) Right click the client in the system tray and select status.
4.) Note the NAT port listed.
5.) Launch the ISA management console and create two protocol
definitions:
Port: 500
Protocol: UDP
Direction: SEND
Port: <the one you noted>
Protocol: UDP
Direction: SEND
Give that a shot.
Jeff Butte
mailto:jbutte@xxxxxx
-----Original Message-----
From: GT [mailto:torchetti@xxxxxxxxxxxx]
Sent: Tuesday, November 06, 2001 7:54 PM
To: [ISAserver.org Discussion List]
Subject: [isalist] cisco vpn dialer (IPSEC)
http://www.ISAserver.org
I have a workstation needing to connect to an external vpn altiga box.
Anyone have any clue as to what filter to enable port/whatever to get
this
working?
Thanks!
torchetti@xxxxxxxxxxxx
------------------------------------------------------
You are currently subscribed to this ISAserver.org Discussion List as:
jbutte@xxxxxx
To unsubscribe send a blank email to $subst('Email.Unsub')
Other related posts:
