Jay, I have applied sp1, what was the pre sp1 hotfix ? I think I will re apply it to my system. I do not want to uninstall sp1 unless I have to, this is a live system and I really do not want to break it any more than it is. Patrick -----Original Message----- From: Jay J. Mobley [mailto:jmobley@xxxxxxxxxx] Sent: 12 February 2002 18:12 To: [ISAserver.org Discussion List] Subject: [isalist] RE: Server published ports stop allowing connections http://www.ISAserver.org I had this problem too pre-SP1 there was a patch then that fixed it and it was supposedly in SP1 ... I applied SP1 about a month ago and yesterday I began to see the same problems begin again. I know.. not much in the way of help, but hopefully you can do something with the info -Jay -----Original Message----- From: patricks@xxxxxxxxxxxxxxxxxx [mailto:patricks@xxxxxxxxxxxxxxxxxx] Sent: Tuesday, February 12, 2002 1:43 AM To: [ISAserver.org Discussion List] Subject: [isalist] Server published ports stop allowing connections http://www.ISAserver.org I seem to have a bit of a stability problem with my ISA Server. Every month or so, my ISA seems to stop allowing connections to certain published services (mail, dns, http etc). Proxy browsing out of our firewall works fine, but anyone accessing services from outside the firewall are refused. I cannot find any patterns. Restarting the services seems to fix the problem. Can anyone give me any pointers on how to troubleshoot this. I would also like to try and setup an alert for when this happens again. As this would run behind the firewall, I am not sure what I can check to see if this problem is happening. Has anyone got any ideas ? Patrick ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: jmobley@xxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub') ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: patricks@xxxxxxxxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub')