Update on this. When I started the host After I added the definitions and rules the host said it can no longer connect. Any ideas? -----Original Message----- From: R. Nath [mailto:nathra@xxxxxxxxxxxxxxxx] Sent: Saturday, March 09, 2002 2:36 AM To: [ISAserver.org Discussion List] Subject: [isalist] PcAnwhere 10 and ISA http://www.ISAserver.org Anybody out there dealt with PcAnywhere and SBS 2000? I am having trouble routing PcAnywhere to the workstations behind the ISA on my SBS 2000 Server. Here is a brief scenario - The system consists of DSL Modem Connected to a D-Link DI-704 router which is, in turn, connected to an SBS Server with 4 workstations. There are two nic cards on the server. The first is the domain card used to connect the workstations (We'll call the IP address on this one 1x.1x.1x.1x). The second(IP address 2x.2x.2x.2x)is directly connected to the router used to access the internet (Of course both the modem and router also have their own IP address along the the WAN (ISP) address.) The workstations are accessing the internet using the DNS address on the server as the gateway. They are all currently able to connect to the internet. Here's the problem. I have setup up 8 TCP and UDP protocol definitions and publishing rules in the ISA to allow 5631, 32, 41 & 42 to pass through. I have also set up the router to allow these ports. However, when I start PCA Host on the server the remote does not see it. I need to know how to resolve this. One the to keep in mind is that I can't turn the RRAS on or I will lose my ISA functionality so how do I work around this? Hopefully I have been clear though I am currently a little befuddled. Any help would be appreciated. Thanks. RAN (P.S. - I understand some where on this web site there is an article written which helps to explain the proper procedures for PCA 10 but I have not been able to find it.) ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: nathra@xxxxxxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub')