This will be on the OWA server. -----Original Message----- From: Joe Leek [mailto:joe@xxxxxxx] Sent: Monday, May 06, 2002 10:09 AM To: [ISAserver.org Discussion List] Subject: [isalist] RE: OWA through ISA Server http://www.ISAserver.org Bill, Thanks for the response. Change to plain text where? On the OWA server or the ISA server? joe _______________________ Joseph H Leek JHL Mail Marketing, Inc. 3100 Borham Avenue Stevens Point WI 54481-5094 Phone: 715.341.0581 x 11 Fax: 715.341.9645 Email: joe@xxxxxxx <mailto:joe@xxxxxxx> -----Original Message----- From: Bill Kuhn - MCSE [mailto:bkuhn@xxxxxxxxxxxxx] Sent: Monday, May 06, 2002 10:05 AM To: [ISAserver.org Discussion List] Subject: [isalist] RE: OWA through ISA Server http://www.ISAserver.org It sounds like you are using something more than plain text authentication for OWA. You should use plain text authentication only. -----Original Message----- From: Joseph Leek [mailto:joe@xxxxxxx] Sent: Monday, May 06, 2002 9:16 AM To: [ISAserver.org Discussion List] Subject: [isalist] OWA through ISA Server http://www.ISAserver.org Hi All: We have set up an ISA server and published OWA through it. My problem is that it takes up to 5 minutes to load a page outside the firewall. Before ISA this was not the case. Has anyone seen this? Is there a solution? TIA joe _______________________ Joseph H Leek JHL Mail Marketing, Inc. 3100 Borham Avenue Stevens Point WI 54481-5094 Phone: 715.341.0581 x 11 Fax: 715.341.9645 Email: joe@xxxxxxx ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: bkuhn@xxxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub') ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: joe@xxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub') ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: bkuhn@xxxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub')