Hay Tom....I know....sorry for being rude....How was your Holiday!...I can see both you and Jim spent quality time on the message board!!.....good hearing from you too! -----Original Message----- From: Thomas W. Shinder [mailto:tshinder@xxxxxxxxxxxxxxxxxx] Sent: Thursday, December 27, 2001 11:47 AM To: [ISAserver.org Discussion List] Subject: [isalist] RE: Message Screener: Content Filtering Failes http://www.ISAserver.org Hi David, Long time no see! Welcome back! :-) Tom -----Original Message----- From: David Dellanno [mailto:ddellanno@xxxxxxxxxxxxxxx] Sent: Thursday, December 27, 2001 8:51 AM To: [ISAserver.org Discussion List] Subject: [isalist] RE: Message Screener: Content Filtering Failes http://www.ISAserver.org Some corrections that I just found if I put my mind to it!....... "Screener does not! Respond to the rules", and I found on Technet "Microsoft ISA Server 2000 - Configuring and Securing Microsoft Exchange 2000 Server and Clients" that answered Step 2 & 3, it should be configured on the ISA server an Everyone should have full control on Step 3. But Messenger still does not work. -----Original Message----- From: David Dellanno Sent: Thursday, December 27, 2001 9:11 AM To: [ISAserver.org Discussion List] Subject: [isalist] Message Screener: Content Filtering Failes http://www.ISAserver.org Hi Tom and Jim, I have searched the entire Message Board and found no answer why the Message Screener does respond to the rules applied on the SMTP Filter on the ISA Server. I have followed your wonderful box... Chapter 9 pages 587 thru 594 to the "T". The design to implement ISA, Internal Mail Relay, and Exchange 2000 are exactly the same as the book describes. I have two inconsistencies on the instructions that did not work in my production environment. 1. On page 590, step 10, I had to select Allow incoming mail to be relayed to the domain checkbox to allow the mail to relay to the Exchange Server 2. On page 592, step 16, it was not clear weather to configure dcomcnfg.exe on the ISA or the Internal Mail Relay, so I configured for both. 3. On page 593, step 18, it was not clear under User custom configuration permissions radio button, what permission Everyone should have, by default it is Read. I'm at the end of my since Microsoft's Knowledge Base and Technet do not have any solutions. Thanks in advanced David Dellanno ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: ddellanno@xxxxxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub') ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: tshinder@xxxxxxxxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub') ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: ddellanno@xxxxxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub')