RE: Cable modem problem

  • From: "Greg Mulholland" <duke@xxxxxxxxxxxxxx>
  • To: "[ISAserver.org Discussion List]" <isalist@xxxxxxxxxxxxx>
  • Date: Fri, 19 Apr 2002 01:19:56 +1000

Cable modem problemHave you enabled the dhcp client filter for you dhcp server 
on your cable network. If so, i would assume it would work then. otherwise, 
what is happening, what address are you given


  ----- Original Message ----- 
  From: Alvarado Jesus 
  To: [ISAserver.org Discussion List] 
  Sent: Friday, April 19, 2002 1:13 AM
  Subject: [isalist] RE: Cable modem problem


  http://www.ISAserver.org


  Take the DHCP address that the Cable co. give you 
  and enter it as a static address , ( cheesey ) it will work until you lease 
expires the switch to dhcp
  get the address and go thru the cycle again
  works for me.
    -----Original Message-----
    From: Dan Bartley [mailto:dan@xxxxxxxxxxxxxxx]
    Sent: Thursday, April 18, 2002 9:21 AM
    To: [ISAserver.org Discussion List]
    Subject: [isalist] Cable modem problem


    http://www.ISAserver.org


    I think. I'm changing from ISDN to a cable modem. The cable co. says I must 
have my ISA server set for DHCP. Followed the instructions in the Learning Zone 
for this type of setup. I tested it against my ISDN router. Set it to do DHCP, 
gave the DHCP Client rule the IP of the ISDN router as the remote computer. It 
won't get an IP from it. I stopped the ISA Control, as suggested, still won't 
get the IP.

    Maybe it is the router, but I thought I would check ahead if anyone has any 
thoughts on what else I might be missing.

    Dan Bartley, MCSE+Internet

    dan@xxxxxxxxxxxxxxx


    ------------------------------------------------------
    You are currently subscribed to this ISAserver.org Discussion List as: 
jalvarado@xxxxxxx
    To unsubscribe send a blank email to $subst('Email.Unsub') 
  ------------------------------------------------------
  You are currently subscribed to this ISAserver.org Discussion List as: 
duke@xxxxxxxxxxxxxx
  To unsubscribe send a blank email to $subst('Email.Unsub') 

Other related posts: