Jack, Something I've found handy is to ADD CIRCLE, then go down to the command line and type in your desired coordinates (e.g. x 1500 y 2000) and the circle will close around that point. Be sure to delete the circle afterwards. Hope this helps. Cheers, Ron Scott C.I.D. Texas Instruments Storage Products Group Tel: 214.567.4715 Cell: 972.816.7978 rg-scott@xxxxxx _____ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of JACK KELLY Sent: Monday, May 16, 2005 09:02 To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: x,y location what is the quickest way to find a particuliar x,y location on a board? thanks in advance.