Hello all. Does anybody know why artworks have an offset from drills and even the netlist when we load them in cam350? I have already seen it with the excellon files and then I used to align drills to the gerber. But now we are loading an IPC 356A netlist to compare with gerber, and we can see that gerbers also have an offset from it. So the error report is consequent...but false of course... How to make gerber with the same origin than drills and IPC nets? Wishing we won't have something to calculate job by job... Thanks in advance and have a nice end of week. William Billereau CERN-TS/DEM PCB Designer PS. I wrote a little SKILL routine that reports ANTIPAD and REGULAR NULL definition for vias/pads used in the board. They are reported as database DRC (eXternally Determined Violation). If someone is interested... ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------