[PCB_FORUM] Re: Pausing on commands, anyone else?

  • From: "Dal Locke" <dlocke@xxxxxxxxxx>
  • To: <icu-pcb-forum@xxxxxxxxxxxxx>
  • Date: Wed, 2 Nov 2005 09:44:14 -0600

Is your software loaded somewhere on the network?  Probably a network delay 
issue loading a remote command.

-----Original Message-----
From: Watts III, Nolan [mailto:nolan.watts.iii@xxxxxxxx]
Sent: Wednesday, November 02, 2005 9:24 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Pausing on commands, anyone else?

I'm seeing fairly consistent behavior out of the Allegro GUI by it pausing on 
certain commands, most repeatable is the Display/Color.  The first time you 
invoke this it takes around 7 seconds for it to appear.  Subsequent picks of it 
brings it up immediately, but NOT if some considerable time has passed, say 30 
minutes.  It is as if there is some sort of caching going on in the UI.  I've 
seen this in both 15.2 and 15.5 and I'm running on high performance Precision 
370 and 670 Dell's with lots of memory(>2Gb), so one might assume hardware 
isn't the limiting factor.  I'm wondering if this is common performance for 
other users.  If so, please reply.  Otherwise, I'll submit a SR to Cadence.

Thanks for your help, 

Nolan Watts 

Other related posts: