I agree too, your memory is fine. The interactive Router doesn't see parallelism when shoving. Best regards. At 02:14 PM 3/16/2012, you wrote:
David,I was not referring to Auto routing but interactive and I do not remember it shoving due to parallelism rules.Excuse me if my memory is fading, Gerry Gerry Meier, Sr. PCB Designer Freedom CAD Services. Inc Voice: (603) 864-1350 ** NEW** Cell: (256) 714-2791 Email:gerry.meier@xxxxxxxxxxxxxx Skype: rgmeier3 visit us at <http://www.freedomcad.com/>http://www.freedomcad.com P Think Green only print as needed.From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of David PriceSent: Friday, March 16, 2012 1:02 PM To: icu-pcb-forum@xxxxxxxxxxxxxSubject: [PCB_FORUM] Re: Max Parallelism not forcing spacing requirements. Only gives a DRC.The Router enforces parallelism perfectly. David At 01:53 PM 3/16/2012, you wrote: Mark,It has never worked that way neither has PCB Router ? to get that you need to assign spacing rulesGerry Meier, Sr. PCB Designer Freedom CAD Services. Inc Voice: (603) 864-1350 ** NEW** Cell: (256) 714-2791 Email:gerry.meier@xxxxxxxxxxxxxx Skype: rgmeier3 visit us at <http://www.freedomcad.com/>http://www.freedomcad.com P Think Green only print as needed.From: <mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx>icu-pcb-forum-bounce@xxxxxxxxxxxxx [ mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Mark SalbergSent: Friday, March 16, 2012 11:45 AM To: <mailto:icu-pcb-forum@xxxxxxxxxxxxx>icu-pcb-forum@xxxxxxxxxxxxxSubject: [PCB_FORUM] Max Parallelism not forcing spacing requirements. Only gives a DRC.Max Parallelism not forcing spacing requirements. Only gives a DRC. I have max Parallelism rules set as below.When I slide these traces together, it will report a DRC, but I would like it NOT to allow me to slide too close together.[]How can I set Allegro to NOT allow these traces too close together. During slide, I have Allowed DRC left UNCHECKED.[] Thanks in advance, Mark