[PCB_FORUM] Max Neck Length
- From: "Macindoe, Gary" <Gary.Macindoe@xxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Mon, 14 Jul 2008 15:57:10 -0500
Hey guys,
Up until now, I haven't had to worry about being even close to a max
neck length spec.
Now I have a max of 500 mils that the neck length can be, and I'm going
to have to use that up.
It looks like the "Max neck length" as specified in a Physical
Constraint Set applies to a cline segment, not the full cline.
If I can only have a max length of 500 mils for the cline (all of the
segments adding up to 500 mils), how can that be set up?
Thanks for any insight into this.
Regards,
Gary
Gary E. MacIndoe
PCB Design Engineer
Fort Collins, Colorado
amd.com
gary.macindoe@xxxxxxx
Other related posts:
