You are correct - I knew that. I had a long dfiscusion with our support on why I only see 3 Gb and Bios sees 4?? -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Walter Boese Jr. Sent: Thursday, February 21, 2008 6:59 AM To: icu-pcb-forum@xxxxxxxxxxxxx; Walter Boese Jr. Subject: [PCB_FORUM] Re: Low on available memory, please exit the program. Not that this is your problem, but for info purposes. Windows XP cannot address 4gig of memory. There is a 3gig switch, but we have found that to be problematic. The only way to address 4gig is with Windows XP Pro 64bit and Cadence does not support 64bit Windows at this time. Walter Boese Jr. SGI Julian Ungureanu (jungurea) wrote: > > I thought I post this here before I open a case with Cadence. > I get this message when updating DRCs. > The brd file is ~100 Mb. > T61P, 2.2 GHz, 4 Gb RAM, Windoze XP > Any ideas why? > > > Thanks, > Julian U. > > -- Walter Boese, Jr. walterb@xxxxxxx ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------