I was thinking you could have a property with DESIGN NAME HERE = ? If you used Custom Text properties can you change it? Mike ________________________________ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Jerry Grzenia Sent: Wednesday, September 30, 2009 10:56 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: Editable text on symbols Sure - You could add a property called "Title" with an initial value "DESIGN NAME HERE". The designers could then change this Title property value to the actual design name. Or - you could use Custom Text properties. Jerry From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Carrow, Dennis Sent: Wednesday, September 30, 2009 9:07 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Editable text on symbols Hello All, How do I place text on my title block symbol that is editable after placing it on a schematic page? I would like to add under Title "DESIGN NAME HERE". Is this possible? Thanks! -DC (Allegro Design Entry HDL 16.2)