On the options tab, turn of "Stretch etch". Richard Weinberg Agere Systems 207-846-4539 -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Vince Di Lello Sent: Monday, April 18, 2005 3:35 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Disappearing Ratsnests Good morning fellow designers, Ladies & Gentlemen, during a Move of a symbol, the ratsnest disappear and then reappear when I put the symbol down on the board. Is there a setting that anyone knows of that will 1: keep the ratsnest on during the move, and 2: length minimize the ratsnest as I move the part around on my cursor? Just wondering ..... thanks as always and I hope everyone has a great day. Vincent Di Lello, CID+ Senior CAD Designer Kaleidescape Canada, Inc. vdilello@xxxxxxxxxxxxxxxx (v) 519.772.6418 (f) 519.772.6401 www.kaleidescape.com