All, When you use blind and buried vias, do use set them up in the board database from an existing regular top to bottom via? Do you create BBV padstacks for your pad library? I see in the padstack editor, Parameters tab, you can set the Type to "Blind/Buried". I've tried to create a BBV padstack in the editor without luck. What do you guys using BBVs do? Create them in the design or in your library? Also, when creating the drill legend for the Fab drawing, if a 1-2 blind via and a 8-7 blind via were created in the database from the same top to bottom via (the same laser drill size in this case), the "figure" in the drill legend is the same. Is this correct, or do you have different "figures" for the 1-2 and 8-7 same size drills? Thanks for any responses! Gary E. MacIndoe PCB Design Engineer Advanced Micro Devices, Inc. Longmont, Colorado