Essam,
IBIS has no timing information such as setup and hold times and clock to out
skew. This information is usually contained in separate timing models for a
component.
Walter
Walter Katz
<mailto:wkatz@xxxxxxxxxx> wkatz@xxxxxxxxxx
Phone 303.449-2308
Mobile 303.335-6156
From: ibis-bounce@xxxxxxxxxxxxx [mailto:ibis-bounce@xxxxxxxxxxxxx] On Behalf ;
Of Ahmed Essam
Sent: Sunday, September 10, 2017 5:30 AM
To: ibis@xxxxxxxxxxxxx; ibis-users@xxxxxxxxxxxxx
Subject: [ibis] Skew between Data and clock pins in IBIS standard
Hi All,
Hope u are fine,i have a question about if the IBIS standard can support any
information about skew between pins of different drivers in the same
component.
In my case , it is required to get the skew between clock and data pins .
Thanks,
Essam