Thanks Bob, I tend to agree with your explanation / logic, but
I wonder if any of this is written down in the spec (other than
the example you mentioned)?
Thanks,
Arpad
================================================
-----Original Message-----
From: Bob Ross [mailto:bob@xxxxxxxxxxxxxxxxx] ;
Sent: Tuesday, April 9, 2019 1:51 PM
To: Muranyi, Arpad <Arpad_Muranyi@xxxxxxxxxx>; 'IBIS-ATM'
<ibis-macro@xxxxxxxxxxxxx>
Cc: bob@xxxxxxxxxxxxxxxxx
Subject: RE: [ibis-macro] Question about the uniqueness of the name arguments
of [Interconnect ***] keywords
Arpad,
[Interconnect Model Set]s can have the same name as long as they are in
different files (including .ibs). The [Interconnect Model Group] set file
referencing syntax allows for same-named sets in different file including "NA"
for the .ibs file. (See examples on page 36.)
[Interconnect Model] within an [Interconnect Model Set] should have the
different names (for error reporting) but the [Interconnect Model] name can be
used again in a different [Interconnect Model Set] even if it describes a
totally different [Interconnect Model] or its connections. However, I cannot
find a rule that states this.
Bob
--
Bob Ross
Teraspeed Labs
www.teraspeedlabs.com
bob@xxxxxxxxxxxxxxxxx
Direct: 503-246-8048
Office: 971-279-5325
-----Original Message-----
From: ibis-macro-bounce@xxxxxxxxxxxxx <ibis-macro-bounce@xxxxxxxxxxxxx> On
Behalf Of Muranyi, Arpad
Sent: Tuesday, April 9, 2019 11:35 AM
To: IBIS-ATM (ibis-macro@xxxxxxxxxxxxx) <ibis-macro@xxxxxxxxxxxxx>
Subject: [ibis-macro] Question about the uniqueness of the name arguments of
[Interconnect ***] keywords
Hello,
I wonder if we spelled out any rules on the name arguments of the [Interconnect
Model Group], Interconnect Model Set] and [Interconnect Model] keywords. I
can't find any such rules in the
v7.0 IBIS specification. While some of these requirements may be obvious, I
think there are some gray areas too.
For example, it seems to be obvious that the name of the [Interconnect Model
Set] keywords have to be unique if they are located within one IBIS file, but I
am not sure what should be the rule for the case when they are in separate .icm
files. It seems that two .icm files may have identical [Interconnect Model
Set] names, because the group keyword references them with file name / set name.
Similarly, what is the requirement for [Interconnect Model] names? Can we have
two of these keywords with the same name in two separate [Interconnect Model
Set] keywords? Or do they have to be unique, even if they are in separate set
keywords?
I apologize if this is all written out in the spec, but I can't find it at the
moment.
Thanks,
Arpad
==========================================================================
---------------------------------------------------------------------
IBIS Macro website : http://ibis.org/macromodel_wip/ IBIS Macro reflector:
//www.freelists.org/list/ibis-macro
To unsubscribe send an email:
To: ibis-macro-request@xxxxxxxxxxxxx
Subject: unsubscribe
---------------------------------------------------------------------
IBIS Macro website : http://ibis.org/macromodel_wip/
IBIS Macro reflector: //www.freelists.org/list/ibis-macro
To unsubscribe send an email:
To: ibis-macro-request@xxxxxxxxxxxxx
Subject: unsubscribe