I thought the level of technical detail was fine. You might want to expand the resistor example by showing the code that actually does the calculations. I think you only need to show the element code for the first example, though. I particularly like the fact that examples were set up and ready to go - the right approach to get people involved. Todd. Todd Westerhoff High Speed Design Group Manager Cisco Systems 1414 Massachusetts Ave Boxboro, MA 01719 email:twesterh@xxxxxxxxx ph: 978-936-2149 ____________________________________________ "Always do right. This will gratify some people and astonish the rest." - Mark Twain ________________________________ From: ibis-macro-bounce@xxxxxxxxxxxxx [mailto:ibis-macro-bounce@xxxxxxxxxxxxx] On Behalf Of Muranyi, Arpad Sent: Friday, February 03, 2006 2:23 PM To: ibis-macro@xxxxxxxxxxxxx Subject: [ibis-macro] Re: First draft of my presentation Todd, Done. Is the level of technical detail right? Need more/less depth? Thanks, Arpad =============================================== ________________________________ From: ibis-macro-bounce@xxxxxxxxxxxxx [mailto:ibis-macro-bounce@xxxxxxxxxxxxx] On Behalf Of Todd Westerhoff (twesterh) Sent: Friday, February 03, 2006 11:18 AM To: ibis-macro@xxxxxxxxxxxxx Subject: [ibis-macro] Re: First draft of my presentation Looks good to me. One small grammatical change I'd make: Slide 4: "complicated buffer's" => "complicated buffer" Todd. Todd Westerhoff High Speed Design Group Manager Cisco Systems 1414 Massachusetts Ave Boxboro, MA 01719 email:twesterh@xxxxxxxxx ph: 978-936-2149 ____________________________________________ "Always do right. This will gratify some people and astonish the rest." - Mark Twain ________________________________ From: ibis-macro-bounce@xxxxxxxxxxxxx [mailto:ibis-macro-bounce@xxxxxxxxxxxxx] On Behalf Of Muranyi, Arpad Sent: Friday, February 03, 2006 1:49 PM To: ibis-macro@xxxxxxxxxxxxx Subject: [ibis-macro] First draft of my presentation Hello everyone, Here is my first draft of my presentation on technical introduction to the macro library. Please send me your comments ASAP so I could make changes before the end of the day. Thanks, Arpad =============================================