All, Currently, BIRD 36.3 does not allow EBD files to be used for connectors: Buffer Issue Resolution Document (BIRD) BIRD ID#: 36.3 ISSUE TITLE: Electric Descriptions of Boards REQUESTER: Stephen Peters, Intel, Hank Herrmann, AMP DATE SUBMITTED: June 23, 1996, Feb. 13, 1997, March 7, 1997, March 31, 1997 DATE ACCEPTED BY IBIS OPEN FORUM: April 8, 1997 ************************************************************************** **** ************************************************************************** **** STATEMENT OF THE ISSUE: There is a need to describe SIMM modules and related type components that consist of one or more ICs mounted on a PCB board that connects them to a system thru a set of pins. The following BIRD proposes a new type of file called .ebd (Electrical Board Description) that addresses this need. This proposal does not encompass an electrical description of connectors and other interconnect devices. However, it is very simple to extend EBD files to accommodate connectors and cables. Consider the following example of a 6 pin connector with sides A and B: [Pin List] signal_name | A side pins A.1 1 A.2 POWER A.3 GND A.4 2 A.5 POWER A.6 GND | B side pins B.1 1 B.2 POWER B.3 GND B.4 2 B.5 POWER B.6 GND Or the following cable with ends A, B, C [Pin List] signal_name | A side pins A.1 1 A.2 POWER A.3 GND A.4 2 A.5 POWER A.6 GND | B side pins B.1 1 B.2 POWER B.3 GND C.1 2 C.2 POWER C.3 GND To make this clear, all we would need to do is change the documentation to allow EBD files to describe connector and add the following additional keywords: EBD_Type Package|Connector|Cable And [Connector Sides] and [Cable Ends] e.g. [Connector Sides] A B [End Connector Sides] [Cable Ends] A B C [End Cable Ends] And words to describe pins in [Pin List] to be of the form < Connector Side>.<pin> Or < Cable End>.<pin> Walter Walter Katz <mailto:wkatz@xxxxxxxxxx> wkatz@xxxxxxxxxx Phone 303.449-2308 Mobile 303.335-6156