WMI Filters can only query WMI classes on the local system. Jamie Nelson | Systems Engineer | Systems Support, Information Technology | I N T E G R I S Health | Phone 405.552.0903 | Fax 405.553.5687 | http://www.integrisok.com -----Original Message----- From: gptalk-bounce@xxxxxxxxxxxxx [mailto:gptalk-bounce@xxxxxxxxxxxxx] On Behalf Of jfvanmeter@xxxxxxxxxxx Sent: Thursday, February 28, 2008 11:26 AM To: gptalk@xxxxxxxxxxxxx Subject: [gptalk] WMI Filter to query an AD attribute Can I create a WMI filter that would that queries for a specific AD attribute and then apply a policy based on the results of the query? ********************************************************************** This e-mail may contain identifiable health information that is subject to protection under state and federal law. This information is intended to be for the use of the individual named above. If you are not the intended recipient, be aware that any disclosure, copying, distribution or use of the contents of this information is prohibited and may be punishable by law. If you have received this electronic transmission in error, please notify us immediately by electronic mail (reply). This e-mail may contain identifiable health information that is subject to protection under state and federal law. This information is intended to be for the use of the individual named above. If you are not the intended recipient, be aware that any disclosure, copying, distribution or use of the contents of this information is prohibited and may be punishable by law. If you have received this electronic transmission in error, please notify us immediately by electronic mail (reply). *********************** You can unsubscribe from gptalk by sending email to gptalk-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field OR by logging into the freelists.org Web interface. Archives for the list are available at //www.freelists.org/archives/gptalk/ ************************