[gps-talkusers] Re: trouble upgrading

  • From: "Kevin Chao" <g.unit89@xxxxxxxxxxxxx>
  • To: <gps-talkusers@xxxxxxxxxxxxx>
  • Date: Thu, 20 Dec 2007 21:02:39 -0800

Sue, 

Below is the section taken directly from the Sendero FAQ: 

When I install the program I get the message "Not Enough Storage".
After you have performed a 1-2-3 (BT) or S-D-F (QT) RESET correctly during the 
installation of the Test Drive or full version of the
Sendero software you get the message "Not enough storage." 

This message can be caused by two things. First, your Flash Disk may be full 
and you should check to see how much free space is on
your Flash Disk. 

To check free disk space do the following: 

Go to the BrailleNote Main Menu by pressing SPACE with dots 1-2-3-4-5-6 on the 
Braille keyboard or the Menu key on the QWERTY
keyboard. 
Select "File manager" from the Main Menu, either by pressing SPACEBAR 
repeatedly and ENTER when you hear File Manager or press F to
go there directly. 
Next select "Directory," from the File Manager sub-menu either by pressing 
SPACEBAR repeatedly and ENTER when you hear Directory or
press D to go there directly. 
At the "Drive?" prompt press SPACEBAR to move to the flash disk. On the BT 
press SPACE with I. On the QT press READ with I. 
Note: You need approximately 2.5 MB free. Check to make sure you don't have any 
unnecessary voice recordings which could be taking
up most of your Flash Disk space.

If your problem isn't a Flash Disk memory problem, the file you downloaded 
could be corrupt, try re-downloading the file again.

http://www.senderogroup.com/faq.htm 

Hope this helps 

Kevin 


-----Original Message-----
From: gps-talkusers-bounce@xxxxxxxxxxxxx 
[mailto:gps-talkusers-bounce@xxxxxxxxxxxxx] On Behalf Of Susan Mangis
Sent: Thursday, December 20, 2007 8:54 PM
To: gps-talkusers@xxxxxxxxxxxxx
Subject: [gps-talkusers] trouble upgrading

Hi, 

Tonight seems to be my night for upgrading. First I performed the 7.5 build
28 upgrade, and it went fine. Then I attempted to install GPS 4.2. I got the
message not enough storage to perform this operation. My flash disk has 25mb
or however they measure it free. This summer when I installed 4.0 it was at
18, 19, or 20. How much free space do I need to do this? Thanks for any
information. 

Sue Mangis 







Other related posts: