[GeoStL] Re: streets & trips problem
- From: "Gale R. Nie" <showme69@xxxxxxxx>
- To: <geocaching@xxxxxxxxxxxxx>
- Date: Sun, 2 Sep 2007 08:05:50 -0500
-
Thanks Bernie. I had found GPS Gate but after doing a lot of searching and
reading I found Garmin's Spanner software on their site that's for the
Garmin 18 but seems to work so far with my 60. It creates a virtual com
port, which is what I believe GPS Gate also does.
Gale
----- Original Message -----
From: "Bernie" <happykraut@xxxxxxxxxxxxx>
To: <geocaching@xxxxxxxxxxxxx>
Sent: Sunday, September 02, 2007 7:34 AM
Subject: [GeoStL] Re: streets & trips problem
Gale, the only way I get mine to work is to use a product called
GPS GATE. I don't like it, but it works. Bernie
--
On Sat Sep 01 13:02:55 PDT 2007, "Gale R. Nie" <showme69@xxxxxxxx>
wrote:
I received my laptop yesterday and installed streets & trips and
the driver for my Garmin 60CSx. I have the gps hooked up to the
computer but I can't get it configured. When I try to configure
the gps, the streets & trips configuration box shows COM4 as the
current port. I scan to try to find the gps and it shows "No gps
device was found" for COM4, COM5 and COM6. If I click on Start
GPS Tracking in streets & trips, it gives me this message: The
com port is available, but no signal is being received. The gps
interface page shows it is connected. Does anyone have any
advice? Thanks.
Gale
****************************************
For List Info or To make _ANY_ changes, including unsubscribing from this
list, click -----> //www.freelists.org/list/geocaching
Missouri Caches Scheduled to be Archived http://tinyurl.com/87cqw
Other related posts:
