Foxboro sella an AB Gateway which is easy enough to configure=20 -----Original Message----- From: foxboro-bounce@xxxxxxxxxxxxx [mailto:foxboro-bounce@xxxxxxxxxxxxx] On Behalf Of Baptiste, Nigel Sent: Monday, May 23, 2005 2:59 PM To: foxboro@xxxxxxxxxxxxx Subject: [foxboro] Foxboro I/A interface with PLC5/30's Hello list, Does anyone have experience interfacing I/A with AB PLC5/30's? I have to integrate the two for combustion control & burner management = =3D on a steam turbine generator unit. The combustion controls would be replaced with the I/A system but the = =3D budget does not permit the replacement of the PLC based BMS. Hence I'm seeking the best way to interface the two systems. Regards, Nigel Baptiste. =20 =20 _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html =20 foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: = mailto:foxboro-request@xxxxxxxxxxxxx?subject=3Djoin to unsubscribe: = mailto:foxboro-request@xxxxxxxxxxxxx?subject=3Dleave =20 _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave