Thanks for the reports. > *minorBUGREPORT: *I select a file in one of the two panes. Then I write a > command in the command line or I activate the output pane. Afterwards, > clicking with the mouse on the same selected file does not activate the > pane. Clicking anywhere else in the pane or on another file activates it. > Doubleclicking the selected file opens it. Thus, as long as the cursor is > active in the command line, I cannot activate the pane that was active > before putting the cursor in the command line by clicking on the already > selected file. I have noticed that this applied to the address bar, as > well. This one is fixed already, in the patch available on the e2 website OtherDownLoads page. > *BUGREPORT: *The Up, Down and Remove buttons do not work when editing the > filetype. This happens when accessing Edit filetype from the contextual > menu. Inside the settings menu everything works fine. Now fixed, ready for next release. I also have a hunch > that the contextual menu should be there, but it is not. If it is not > supposed, a contextual menu with Cut, Copy etc. would be nice. The filetypes dialog accessed from the context menu is intended to be for simple, relatively minor tweaks, using the buttons (when they work), and by dragging of rows. Adding copy/cut/paste functionality would be a substantial effort. (Without wanting to get too technical, the underlying data structures are messy, in order to accommodate the simpler form of presentation. So handling of cut/copied items is a whole lot more complicated than for the normal config dialog). I recommend using the filetypes page of the normal config dialog for any editing which needs cut/copy/paste. Regards Tom -- Users can unsubscribe from the list by sending email to emelfm2-request@xxxxxxxxxxxxx with 'unsubscribe' in the subject field or by logging into the web interface.