-----Original Message----- From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Dani Lynn Uesato Sent: Saturday, April 24, 2004 5:27 AM To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] Versapoint and Multiple Pages Feeding after Embossing I'm using an old Versapoint with Duxbury 10.4. I'm embossing a document with no page codes or new line codes at the end of it. I looked at the global settings and made sure that Interpoint wasn't checked. My lines per page in DBT is set to 26, and on the Versapoint, it's set to 26 as well; in DBT the desired lines is set to 25, and the document is less than that. Why do extra pages get fed through the embosser after a document is embossed? Is there a way to prevent extra pages from being sent? Thanks, Dani * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * * * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *