[duxuser] Re: embosser setup
- From: "Jean Menzies" <jemenzies@xxxxxxx>
- To: <duxuser@xxxxxxxxxxxxx>
- Date: Tue, 22 May 2012 08:49:56 -0600
Kathy,
You don't need to mess with the embosser settings. For easier operation,
start by resetting your embosser to factory defaults, and then use the
Duxbury settings to control the embossing. It's much easier that way. Start
by defining the embosser paper size, lines per page, characters per line,
etc., in the Global settings for the embosser. Then fine tune as needed with
the Document Settings option for each document. Note that as you do this,
you will see in the dialogue a checkbox for interpoint embossing.
Jean
* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to duxuser-request@xxxxxxxxxxxxx . You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting www.freelists.org . The list archive
* is also located there.
* Duxbury Systems' web site is www.duxburysystems.com
* * *
Other related posts:
